Delock USB Type-C™ converter for 1 x M.2 NVMe SSD+1 x SATA SSD/HDD with clone function

This converter from Delock enables the simultaneous operation of an M.2 NVMe SSD, in 2280, 2260 and 2242 format, and a 2.5″ or 3.5″ SATA HDD or SSD via the USB-C™ interface.

Clone function without PC
The integrated clone function enables storage to be cloned without the use of a PC. It is possible to clone from NVMe to SATA and SATA to NVMe.

Extensive connection options
Thanks to the specially designed adapter, the Delock converter can also be connected quickly and easily to the USB type-A socket. This means it can be easily connected to new devices with a USB Type-C™ socket and older devices that only have a USB Type-A port. The adapter is located directly on the cable and therefore cannot get lost.

SSD installation without tools
No tools are needed to install the M.2 SSD. The cover can be pushed back with a little pressure, the SSD is attached to the board with a rubber nipple and then the cover is pushed back on until it clicks into place.

• Connectors: 1 x SuperSpeed USB 10 Gbps (USB 3.2 Gen 2) USB Type-C™ socket, 1 x 67 pin M.2 Key M slot ,1 x SATA 6 Gb/s 22 pin socket, 1 x DC power socket
• Chipset: JMicron JMS581D
• Supports M.2 modules in 2280, 2260 and 2242 format with Key M or Key B+M on PCIe (NVMe) basis
• Maximum height of components on the module: 1.5 mm, use of double-sided modules possible
• For 2.5″ and 3.5″ SATA HDDs / SSDs
• Supports NVM Express (NVMe)
• Supports S.M.A.R.T
• Supports TRIM
• Supports Native Command Queuing (NCQ)
• Data transfer rate up to 10 Gbps
• Supports UASP
• 7 x LED display for power, access and copy status
• Bootable
• Function keys: 1 x clone key, 1 x on/off switch, 1 x switch for clone mode
• Dimensions (LxWxH): approx. 102 x 67 x 14 mm
• Hot plug, plug & play

Power supply specification

• Plug-in power supply unit
• Input: AC 100 ~ 240 V / 50 ~ 60 Hz / 0.6 A
• Output: 12 V / 2 A
• Ground outside, plus inside
• Dimensions: inside: ø approx.2.5mm, outside:ø approx.5.5 mm,length: approx.10 mm

System requirements

• Android 11.0 or higher
• Chrome OS
• Linux Kernel 5.11 or higher
• Mac OS 11.2.3 or higher
• Windows 8.1/8.1-64/10/10-64/11
• iPad Air (4th generation) or higher
• iPad Pro (3rd generation) or higher
• Surface Pro 7
• PC or notebook with an available USB Type-A port or
• Device with an available USB Type-C™ port or with an available Thunderbolt™ 3 port

Package contents

• USB Type-C™ converter
• Cable USB-C™ male to USB-C™ male (with adapter to USB Type-A male),
• Length approx. 30 cm
• 1 x heat conduction pad
• 1 x heat conduction plate
• External power supply unit 12.0 V / 2.0 A
• Operating instructions