ZMEEZUNO2 - Z-Uno 2, Z-Wave Board for Arduino

Z-Wave.Me Z-Uno 2 - Z-Wave Board for Arduino

The Z-Wave.Me Z-Uno 2 Z-Wave Board for Arduino is the perfect solution for DIY scenarios! Connect LEDs, buttons, switches, motors or any low voltage sensors including most of Arduino compatible sensors.

Create your personalized Z-Wave device by writing sketch in simplified C language. Z-Wave.Me Z-Uno 2 is the optimal companion for your RaZberry gateway.

Features:

• Control any Arduino compatible peripherals
• Define your own logic by modifying your sketch
• Use Arduino IDE and language to write and upload sketches
• Easy-to-use
• Requires no knowledge of Z-Wave protocol
• Complete DIY solution
• Z-Wave 700 series

Hardware Specification

• 40 kB Flash memory for your sketches
• 8 kB RAM
• 2 kB EEPROM
• Z-Wave RF transmitter at 9.6/40/100 kbps
• 26x GPIOs, 15x are 5V tolerant, 5x are able to wake up device from deep sleep
• 4x ADC
• 4x PWM
• 3x UART
• 3x SPI
• 16x interrupts
• 1x I2C
• 2x 16-bit timers, 1x 32-bit timer (GPT)
• 1-Wire (software) (overlaps with special hardware controllers)
• 2x service LEDs
• 1x service button
• 1x user test LED
• CSEN interface for capacitive touch buttons
• LDMA controller for fast data transfers
• 32-bit Cortex M4F @ 39 MHz CPU

Channel Types

• Binary switch
• Multilevel switch
• Color switch
• Binary sensor
• Multilevel sensor
• Meter

Z-Wave supported features

• Z-Wave Plus V2 compliant
• Support of Z-Wave Smart Start technology
• Z-Wave Long Range support
• All Z-Wave frequencies
• AES 128-bit security S2 and S0 modes
• OTA or USB firmware updates
• Multichannel (32 channels)
• 32 association groups
• Controls switches, dimmers, door locks and scenes
• Works with gateways and/or directly with other Z-Wave devices

Additional Data

• Article dimensions (W x H x L): 20.6 x 38.8 x 14 mm
• Package dimensions (W x H x L): 47 x 41 x 20 mm
• Article net weight: 0.008 kg
• Article gross weight: 0.014 kg
• Z-Wave Plus: Yes
• WEEE: Yes
• CE: Yes
• IP rating: 20