Banana Pi Camera Module for BPI-M2+ (OV5640)
OV5640 camera module for Banana Pi BPI-M2+.
Please note: This module is not the same as for BPI-M1/-M1+/M2. The Banana Pi BPI-M2+ directly supports the OV5640 module, so theres no need for an expansion board. You can directly use the OV5640 module on the CSI interface.
If you have a BPI-M1/M1+/M2 camera module, you can remove the camera module from the expansion board and use it on the BPI-M2+.
- Active array size: 2592 x 1944
- Power supply:
- Core: 1.5 V +/- 5 % (with embedded 1.5 V regulator)
- Analog: 2.6 ~ 3.0 V (2.8 V typical)
- I/O: 1.8 / 2.8 V
- Power requirements:
- Active: 140 mA
- Standby: 0.002 mA
- Temperature range:
- Operating: -30 °C to 70 °C junction temperature
- Stable image: 0 °C to 50 °C junction temperature
- Output formats: 8-/10-bit RGB RAW output
- Lens size: 1/4"
- Lens chief ray angle: 24°
- Input clock frequency: 6 ~ 27 MHz
- Max. S/N ratio: 36 dB (maximum)
- Dynamic range: 68 dB (at) 8x gain
- Maximum image transfer rate:
- QSXGA (2592 x 1944): 15 fps
- 1080p: 30 fps
- 1280 x 960: 45 fps
- 720p: 60 fps
- VGA (640 x 480): 90 fps
- QVGA (320 x 240): 120 fps
- Sensitivity: 600 mV/Lux-sec
- Shutter: rolling shutter / frame exposure
- Maximum exposure interval: 1964 x tROW
- Pixel size: 0.0014 x 0.0014 mm
- Dark current: 8 mV/s (at) 60 °C junction temperature