PTP 650 AC+DC Enhanced Power Injector 56V

The power supply unit is an indoor unit that is connected to the ODU and network terminating equipment using Cat5e cable with RJ45 connectors. It is also plugged into an AC or DC power supply so that it can inject Power over Ethernet (POE) into the ODU.

The AC+DC Enhanced Power Injector accepts both AC and DC input, tolerates a greater temperature range, and allows the ODU to support a device on the Aux port, such as a video camera or wireless access point. It also allows the ODU to provide DC power output.

The PSU ODU ports are designed to connect only to PTP 650 ODUs, PTP-SYNC units, NIDUs or LPUs. Do not connect any other equipment, as damage may occur.

Do not connect the PIDU Plus PTP 300/500/600 Series to the PTP 650 ODU or LPU.

Interface

• 100-240V 47-63Hz 1.5A: AC power input (main supply).
• DC In: Alternative DC power supply input.
• DC Out: DC power output to a second PSU (for power supply redundancy) or to a NIDU.
• ODU: RJ45 socket for connecting Cat5e cable to ODU.
• LAN: RJ45 socket for connecting Cat5e cable to network.
• Power (green) LED: Power supply detection
• Ethernet (yellow) LED: Ethernet traffic detection

Specification

• Dimensions: 250 mm x 40 mm x 80 mm
• Weight: 0.864 Kg
• Temperature: -40 °C to +60 °C
• Humidity: 0 to 90% non-condensing
• Waterproofing: Not waterproof
• AC Input: 90-264 V AC, 47-60 Hz
• Alternative DC Input: 37-60 V DC
• DC Output Voltage: For mains input: 58 V, +2V, -0V; For DC input: Output voltage at maximum rated output current, not more than 1.5 V below the DC input voltage. Maximum length of DC output cable: 3 meters.
• AC Input connector: IEC-320-C8
• DC Output current: 1.7A
• Efficiency: Better than 84%
• Over Current Protection: Hiccup current limiting, trip point set between 120% to 150% of full load current
• Hold up time: At least 20 milliseconds
• Power factor: Better than 0.9